Dip 5 mm Round Purple UV LED Diode Water Clear for collect or kill mosquito

DL-504UVCA-UV380.pdf
Dip 5 mm Round Purple UV LED Diode / High power uv led light Water Clear 365nm 375nm 380nm 395nm 400nm 410nm
 

• Features:

1. Popular T-1 3/4 diameter package.
2. No IR emission. Ideal for heat sensitive materials.
3. Instant on and instant off.
4. Long life.
5. Sharp spectrum.
6. Compact light (free design).
7. Power is adjustable by current (No Shutters Needed).
8. Ability to operate in low temperature.
9. Impact resistance.
10. The product itself will remain within RoHS compliant Version.

• Applications:

1. Photo catalyst excitation.
2. Phosphor excitation.
3. Sensor.
4. QA equipment.
5. Counterfeit Bill Detection.

 
Package Dimension:

 
 

 
Absolute Maximum Ratings at Ta=25℃

 
Electrical Optical Characteristics at Ta=25℃

 
Notes:

1. Luminous Intensity Measurement allowance is ± 10%.
2. θ_1/2 is the off-axis angle at which the luminous intensity is half the axial luminous intensity.

• Please read the following notes before using the product:

1. Over-current-proof

Customer must apply resistors for protection, otherwise slight voltage shift will cause big current change (Burn out will happen).

1. Storage

2.1 Do not open moisture proof bag before the products are ready to use.

2.2 Before opening the package, the LEDs should be kept at 30℃ or less and 90%RH or less.

2.3 The LEDs should be used within a year.

2.4 After opening the package, the LEDs should be kept at 30℃ or less and 70%RH or less.

2.5 The LEDs should be used within 168 hours (7 days) after opening the package.

1. Soldering Condition

3.1 Pb-free solder temperature profile

3.2 Reflow soldering should not be done more than two times.

3.3 When soldering, do not put stress on the LEDs during heating.

3.4 After soldering, do not warp the circuit board.

1. Soldering Iron

Each terminal is to go to the tip of soldering iron temperature less than 260℃ for 5 seconds within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do soldering of each terminal. Be careful because the damage of the product is often started at the time of the hand solder.

1. Repairing

Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a double-head soldering iron should be used. It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing.

1. Caution in ESD

Static Electricity and surge damages the LED. It is recommended to use a wrist band or anti-electrostatic glove when handling the LED. All devices equipment and machinery must be properly grounded.
 
Company introduction:
HongKong Double Light Electronics was founded in 2005 as a professional LED manufacturer located in Shenzhen, China. We mainly produce a wide range of products with automatic production lines, which include UV LED, THT LEDs, chip LEDs, LED displays, 5mm lamp LED, infrared LEDs, dot matrix, LCD backlights and LED lighting fixtures.