10 Segment Light Bars LED Digital Display Super Bright Red Black Diffused Lens Type

Datasheet: DLL-R1025RB.pdf              

10 Segment Light Bars LED Digital Display Super Bright Red Black Diffused Lens Type

       This is our 10 Segment Light Bars Displays, its source color can be customed.

Features:

• Industrial standard size.
• Low power consumption.
• Categorized for luminous intensity.
• The product itself will remain within RoHS compliant Version.

Descriptions:

• The DLL-R1025 series is 10 Segment light bar display, designed for viewing distances up to 7 meters.

Applications:

• Audio equipment.
• Instrument panels.
• Digital read out display.

Device Selection Guide:

Package Dimension:

Notes:

• All dimensions are in millimeters (inches).
• Tolerance is ± 0.25 mm (.010″) unless otherwise noted.
• Specifications are subject to change without notice.

Absolute Maximum Ratings at Ta=25℃

Electrical Optical Characteristics at Ta=25℃

Notes:

• Luminous intensity is measured with a light sensor and filter combination that approximates the CIE eye-response curve.
• The dominant wavelength (λd) is derived from the CIE chromaticity diagram and represents the single wavelength which defines the color of the device.

Typical Electrical / Optical Characteristics Curves

(25℃ Ambient Temperature Unless Otherwise Noted)

Please read the following notes before using the datasheets:

1. Over-current-proof

Customer must apply resistors for protection, otherwise slight voltage shift will cause big current change (Burn out will happen).

2. Storage

2.1 Do not open moisture proof bag before the products are ready to use.

2.2 Before opening the package, the LEDs should be kept at 30℃ or less and 90%RH or less.

2.3 The LEDs should be used within a year.

2.4 After opening the package, the LEDs should be kept at 30℃ or less and 70%RH or less.

3. Soldering Condition

3.1 Pb-free solder temperature profile.

3.2 Reflow soldering should not be done more than two times.

4. Soldering Iron

Each terminal is to go to the tip of soldering iron temperature less than 260℃ for 5 seconds within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do soldering of each terminal. Be careful because the damage of the product is often started at the time of the hand solder.

5. Repairing

Repair should not be done after the LEDs have been soldered. When repairing is unavoidable,

a double-head soldering iron should be used. It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing.

For more details, please contact us.

Email: Facebook@doublelight.com.cn