Payment & Shipping Terms:
|Product Name:||5mm Round PN Junction Silicon Photodiode||Package:||DIP 5mm Round Standard LEDs|
|Emitted Color:||Photodiode Receiver||Peak Emission Wavelength:||940nm|
|Lens Type:||Water Clear||Viewing Angle:||40 Deg|
light emitting diode led,
ir emitting diode
5Mm Round PN junction Silicon Photodiode 940nm Peak Emission Wavelength
This is our 5mm Round PN junction Silicon Photodiode, its lens color is water clear.
|Part No.||Chip Material||Lens Color||Source Color|
|DL-5586PD-1PD||Silicon||Water Clear||Photodiode Receiver|
Absolute Maximum Ratings at Ta=25℃
|Operating Temperature Range||Topr||-25℃ to +80℃|
|Storage Temperature Range||Tstg||-40℃ to +85℃|
Lead Soldering Temperature
[4mm (.157″) From Body]
Electrical Optical Characteristics at Ta=25℃
|Peak sensitivity Wavelength||λ p||—||940||—||nm||—|
|View Angle||2θ1/2||35||40||45||deg||VR=5V λ=940nm|
|Angle off center||Δθ||-5||—||5||deg|
Typical Electrical / Optical Characteristics Curves
(25℃ Ambient Temperature Unless Otherwise Noted)
Please read the following notes before using the datasheets:
Customer must apply resistors for protection, otherwise slight voltage shift will cause big current change (Burn out will happen).
2.1 Do not open moisture proof bag before the products are ready to use.
2.2 Before opening the package, the LEDs should be kept at 30℃ or less and 90%RH or less.
2.3 The LEDs should be used within a year.
2.4 After opening the package, the LEDs should be kept at 30℃ or less and 70%RH or less.
2.5 The LEDs should be used within 168 hours (7 days) after opening the package.
3. Soldering Condition
3.1 Pb-free solder temperature profile.
3.2 Reflow soldering should not be done more than two times.
3.3 When soldering, do not put stress on the LEDs during heating.
3.4 After soldering, do not warp the circuit board.
4. Soldering Iron
Each terminal is to go to the tip of soldering iron temperature less than 260℃ for 5 seconds within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do soldering of each terminal. Be careful because the damage of the product is often started at the time of the hand solder.
Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a double-head soldering iron should be used (as below figure). It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing.
6. Caution in ESD
Static Electricity and surge damages the LED. It is recommended to use a wrist band or anti-electrostatic glove when handling the LED. All devices equipment and machinery must be properly grounded.
Contact Person: min