Payment & Shipping Terms:
|Product Name:||Piranha Super Flux With 3mm Dome 4 Lead Super Yellow LED Indicators||Package:||Piranha Super Flux LED|
|Emitted Color:||Super Yellow||Product Number:||DL-U30UYCA-2UY70|
|Dominant Wavelength:||590nm||Lens Type:||Water Clear|
|Forward Voltage @20ma:||1.8-2.2V||Viewing Angle:||70 Deg|
|Application:||Indicator Light,Electric||Luminous Intensity:||1000-1500mcd|
multi color led diode,
green light emitting diode
This is Piranha Super Flux with 3mm Dome 4 Lead Super Yellow LED Indicators, its lens color is water clear and the emitting color of this size is changeable.
|Part No.||Chip Material||Lens Color||Source Color|
|DL-U30UYCA-2UY70||AlGaInP||Water Clear||Super Yellow|
Absolute Maximum Ratings at Ta=25℃
Peak Forward Current
(1/10 Duty Cycle, 0.1ms Pulse Width)
|Electrostatic Discharge (HBM)||ESD||2000||V|
|Operating Temperature Range||Topr||-40℃ to +85℃|
|Storage Temperature Range||Tstg||-40℃ to +100℃|
|Lead Soldering Temperature||Tsld||260℃ for 5 Seconds|
Electrical Optical Characteristics at Ta=25℃
|Luminous Intensity *||IV||1000||1500||---||mcd||IF=20mA (Note 1)|
|Viewing Angle *||2θ1/2||---||70||---||Deg||IF=20mA (Note 2)|
|Peak Emission Wavelength||λp||---||592||---||nm||IF=20mA|
|Dominant Wavelength||λd||---||590||---||nm||IF=20mA (Note 3)|
|Spectrum Radiation Bandwidth||Δλ||---||15||---||nm||IF=20mA|
Typical Electrical / Optical Characteristics Curves
(25℃ Ambient Temperature Unless Otherwise Noted)
Please read the following notes before using the product:
Customer must apply resistors for protection, otherwise slight voltage shift will cause big current change (Burn out will happen).
2.1 Do not open moisture proof bag before the products are ready to use.
2.2 Before opening the package, the LEDs should be kept at 30℃ or less and 90%RH or less.
2.3 The LEDs should be used within a year.
2.4 After opening the package, the LEDs should be kept at 30℃ or less and 70%RH or less.
2.5 The LEDs should be used within 168 hours (7 days) after opening the package.
Each terminal is to go to the tip of soldering iron temperature less than 260℃ for 5 seconds within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do soldering of each terminal. Be careful because the damage of the product is often started at the time of the hand solder.
Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a double-head soldering iron should be used (as below figure). It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing.
Static Electricity and surge damages the LED. It is recommended to use a wrist band or anti-electrostatic glove when handling the LED. All devices equipment and machinery must be properly grounded.
Choose DOUBLE LIGHT, your expert LED components nearby!
Please contact with me to help you find your right product and get your best price .
Contact Person: min