Payment & Shipping Terms:
|Product Name:||Dot Matrix LED Displays||Package:||22*30 Mm Dots 5*7|
|Emitted Color:||Ultra White||Forward Current Per Segment:||25mA|
|Chip Material:||InGaN||Face Color:||Black|
|Forward Voltage @20ma:||3.3V||Luminous Intensity:||120mcd|
led bar display,
alphanumeric led display
1.2 inch 3.45mm Dots 5×7 Ultra White Dot Matrix LED Displays Screen Board with 7 pin Line for Audio equipment
Know more details,please downlaod specifications:DL-S34571CWB.pdf
|Model No.||Chip Material||Source Color||Description|
NOTES: All dimensions are in millimeters (inches) tolerance are ±0.25mm (0.01inch) unless otherwise noted.
|Power Dissipation Per Segment||PD||90||mW|
Peak Forward Current Per Segment
|Forward Current Per Segment||IF||25||mA|
|Dating Linear From 50℃||0.4||mA/℃|
|Operating Temperature Range||Topr||-40℃ to +80℃|
|Storage Temperature Range||Tstg||-40℃ to +85℃|
|Soldering Temperature||Tsld||260℃ for 5 Seconds|
|Luminous Intensity||Iv||60.||120.0||---||mcd||IF=20mA (Note 1)|
|Luminous Intensity Matching Ratio (Segment To Segment)||Iv-m||---||---||2:1||IF=10mA|
|Y||---||0.31||---||nm||IF=20mA (Note 2)|
|Spectral Line Half-Width||△λ||---||20||---||nm||IF=20mA|
(25℃ Ambient Temperature Unless Otherwise Noted)
Customer must apply resistors for protection, otherwise slight voltage shift will
cause big current change ( Burn out will happen ).
2.1 Do not open moisture proof bag before the products are ready to use.
2.2 Before opening the package, the LEDs should be kept at 30℃ or less and 90%RH or less.
2.3 The LEDs should be used within a year.
2.4 After opening the package, the LEDs should be kept at 30℃ or less and 70%RH or less.
3. Soldering Condition
3.1 Pb-free solder temperature profile.
3.2 Reflow soldering should not be done more than two times.
4. Soldering Iron
Each terminal is to go to the tip of soldering iron temperature less than 260℃ for 5 seconds
within once in less than the soldering iron capacity 25W. Leave two seconds and more
intervals, and do soldering of each terminal. Be careful because the
damage of the product is often started at the time of the hand solder.
Repair should not be done after the LEDs have been soldered. When repairing is unavoidable,
a double-head soldering iron should be used. It should be confirmed beforehand whether the characteristics of the LEDs will or will not be damaged by repairing.
HongKong Double Light Electronics was founded in 2005 as a professional LED manufacturer located in Shenzhen, China. We mainly produce a wide range of products with automatic production lines, which include THT LEDs, chip LEDs, LED displays, infrared LEDs, dot matrix, LCD backlights and LED lighting fixtures.
Why choose DOUBLE LIGHT?
1. Well-known chip material
2. 99.99% gold wire bonding
3. 3 years warranty
4. Over 10 years work experience technical service team
5. 24 hours service Professional sales team
6. Free Sample is available
7. Fast delivery
8.100% QC inspection Before Shippment
9. Aiming at the consult of "high quality, zero defect”, give you the best quality, best service.
Contact Person: min